DIY Window Installation Troubleshooting in Idaho, ID
Your satisfaction with your Pella windows and doors is our top priority. Should you have a problem with your Pella product that you believe might be related to the window’s installation, completing the following steps can help determine if the product is installed level, square and plumb.
First, grab a level and set it on the frame of the product, across the bottom or sill. Do not set it on the sashes or panels of the product because it may produce an inaccurate reading. The bubble of your level should settle in the center, demonstrating the product is installed level.
Next, examine plumb of your window or door. Plumb means the window or door is straight down or up, vertically. To examine for plumb, place your level on the two vertical side jambs on the exterior face to ensure the product is plumb from the inside out. After that, you’ll check for plumb from left to right by placing the level on each of the two sides. The bubble should fall in the middle on both sides, indicating the product is installed plumb.
After checking plumb, you can look for bowing by measuring the unit horizontally across the top, middle and bottom. The measurements of each of the three places should all be equal, plus or minus one eighth of an inch. It’s important to always measure to and from a single point on both sides for consistency. Finally, see if your window or door is square by measuring from one corner to the other in an X fashion on the outside of the product. The measurements should be within 1/8 inch of each other for the product to be installed square.
You can also examine the reveal, where the sash meets the frame. The gap should look the same from top to bottom and left to right. All sides of your product should appear the same, signifying the product is installed level, square, and plumb.
Doing a little troubleshooting on your own can offer helpful information to solve a problem. If it is clear you have run in to one, or even a couple, of these issues, stop by the Pella Window and Door Showroom in Idaho or give us a call at 208-373-0002.